Total Complaints
1 filings
VOLVO VT · model year
1 NHTSA complaints, and 9 active recalls for this specific cohort.
NHTSA overall rating
Not crash-tested
New Car Assessment Program
The 2007VOLVOVT carries 1 consumer safety complaint in NHTSA's Office of Defects Investigation database for this specific model-year cohort. Within that volume, owners reported 0 crashes, 0 fires, 0 injuries, and 0 fatalities. No NCAP 5-star crash-test rating is available for this model year in the federal database.
Component-level analysis is where model-year complaints become actionable: the top complaint category for the 2007 VT is visibility:glass, side/rear with 1 filings. Concentration in one or two component groups is the classic signature of a systemic defect; a flat distribution usually reflects normal aging, warranty complaints, or isolated build-plant variability. This model year has 9 active recall campaigns, which means the manufacturer is obligated to remedy the covered defect at no charge for the life of the vehicle — the full NHTSA campaign numbers are listed below.
NHTSA currently has 28 investigation files overlapping the 2007 VT. Owners comparing this cohort against neighboring years should pair the counters above with the complaint-by-year trend on the parent model page — a spike in a single year often tracks to a platform refresh, a new transmission supplier, or an updated ECU calibration. Use the related-complaint feed below to read raw owner narratives before deciding whether any pattern here affects your specific use case.
Total Complaints
1 filings
Crashes Reported
0 reports
Source
NHTSA ODI
Federal complaints database
At or below the fleet median complaint volume.
| Component | Count |
|---|---|
| VISIBILITY:GLASS, SIDE/REAR | 1 |
POWER TRAIN:CLUTCH ASSEMBLY
Volvo Trucks North America (Volvo) is recalling certain model year 2007-2014 VAH, VHD, VNL, VNM, and VT models. The affected vehicles were built without a redundant clutch disengagement switch. Without a redundant switch, a loss of signal from the brake air pressure switch can prevent the clutch fr
STEERING
ON CERTAIN TRUCKS, THE NUT USED TO RETAIN THE STEERING SHAFT MAY OR MAY NOT BE A LOCK NUT THAT HAS THE LOCKING FEATURE. A LOCK NUT IS REQUIRED TO PROVIDE ADDITIONAL RESISTANCE TO ENSURE THAT THE NUT DOES NOT COME LOOSE.
TRAILER HITCHES:FIFTH WHEEL ASSEMBLY
ON CERTAIN TRUCKS EQUIPPED WITH A SAF HOLLAND SIMPLEX FIFTH WHEEL, THE LEVER ARM PIVOT BOLT MAY HAVE BEEN OVER TIGHTENED. AN OVER TIGHTENED PIVOT BOLT CAN DISTORT THE PIVOT BOLT SPACER SLEEVE, WHICH MAY PREVENT THE FIFTH WHEEL LATCH JAW FROM CLOSING AND LATCHING SECURELY AROUND THE TRAILER KING PI
VISIBILITY:WINDSHIELD WIPER/WASHER:MOTOR
VOLVO TRUCKS IS RECALLING 127,764 MY 2001-2008 VHD, VNL, VNM, AND MY 2005-2008 VT TRUCKS. A SEAL MAY FAIL ALLOWING WATER AND CONTAMINANTS TO SEEP INTO THE WINDSHIELD WIPER MOTOR.
ELECTRICAL SYSTEM:WIRING:FUSES AND CIRCUIT BREAKERS
ON CERTAIN HEAVY DUTY TRUCKS, THE CIRCUIT PROTECTION (I.E. AUTOMATIC CIRCUIT BREAKERS) USED TO PROTECT THE VEHICLE LIGHTING SYSTEM MAY NOT PROVIDE ADEQUATE PROTECTION.
SERVICE BRAKES, AIR:SUPPLY:QUICK RELEASE VALVE
VOLVO TRUCKS IS RECALLING CERTAIN MODEL YEAR 2007 AND 2009 VHD, MODEL YEAR 2006 THROUGH 2010 VN, AND MODEL YEAR 2007 THROUGH 2009 VT TRUCKS MANUFACTURED FROM NOVEMBER 7, 2005, THROUGH OCTOBER 30, 2009, EQUIPPED WITH AN AIR RELEASE FIFTH WHEEL. THE INVERSION VALVE ON THE FRAME MAY BE ORIENTATED WHER
POWER TRAIN:DRIVELINE
ON CERTAIN TRUCKS EQUIPPED WITH ARVINMERITOR RPL20 HIGH ANGLE INTERAXLE DRIVESHAFTS, AN IMPROPER SEATED OR MISSING SNAP RING CAN RESULT IN THE BEARING CUP TO SEPARATE FROM THE SLIP YOKE SUB-ASSEMBLY. THE UNIVERSAL JOINT CROSS COULD THEN CONTACT THE SLIP YOKE CASTING AND EVENTUALLY CAUSE THE EAR WOR
FUEL SYSTEM, DIESEL
ON CERTAIN TRUCKS, AN UNPROTECTED LEAD IN THE THERMOSWITCH OF THE HEATER MAY MAKE CONTACT WITH ANOTHER POST POSSIBLY CREATING A SHORT CIRCUIT, WHICH CAN RESULT IN CONTINUOUS OPERATION OF THE HEATING ELEMENT.
STEERING:GEAR BOX:SHAFT SECTOR
ON CERTAIN HEAVY DUTY CLASS 8 TRUCKS EQUIPPED WITH DANA STEERING SHAFTS, THERE IS A POTENTIAL THAT THE STEERING SHAFT PINCH BOLT HOLE MAY BE INCORRECTLY LOCATED. THE PINCH BOLT FITS INTO A GROOVE IN THE STEERING GEAR INPUT SHAFT TO ENSURE THAT THE STEERING SHAFT DOES NOT SEPARATE FROM THE STEERING
2007 VOLVO VT, DRIVERS SIDE WINDOW SHATTERED. *BF OHIO TRAFFIC CRASH REPORT # 10-0293-91 UPDATED 05/03/10 *BF
Data as of 2025. Sources: NHTSA Office of Defects Investigation (ODI) complaints database, NHTSA recall campaign API, NHTSA NCAP crash-test ratings, and NHTSA FARS for fatality cross-reference.
Read our methodology — how this data is sourced, computed, and verified.