2001 VOLVO VHD

TRAILER HITCHES:FIFTH WHEEL ASSEMBLY

ON CERTAIN HEAVY DUTY TRUCKS EQUIPPED WITH JOST INTERNATIONAL JSK 37U SERIES FIFTH WHEELS, A FATIGUE CRACK CAN DEVELOP IN THE BRACKET PIN WELD UNDER CERTAIN LOADING CONDITIONS.

SERVICE BRAKES, AIR:CONTROLS, PEDALS AND LINKAGES

VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS BUILT WITH A STEERABLE AUXILIARY AXLE AND EQUIPPED WITH CERTAIN MERITOR-WABCO BRAKE SYSTEM TWO AND FOUR PORT RELAY VALVES. THE VALVE MAY STICK OPEN WHEN A HIGH-PRESSURE APPLICATION IS RELEASED.

VISIBILITY:WINDSHIELD WIPER/WASHER:MOTOR

VOLVO TRUCKS IS RECALLING 127,764 MY 2001-2008 VHD, VNL, VNM, AND MY 2005-2008 VT TRUCKS. A SEAL MAY FAIL ALLOWING WATER AND CONTAMINANTS TO SEEP INTO THE WINDSHIELD WIPER MOTOR.

SEAT BELTS:FRONT:ANCHORAGE

CERTAIN HEAVY DUTY CLASS 8 TRUCKS EQUIPPED WITH AN OPTIONAL TWO-MAN PASSENGER BENCH SEAT FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 210, "SEAT BELT ASSEMBLY ANCHORAGES." ON THE TWO-MAN PASSENGER BENCH SEAT INBOARD (CENTER) POSITION, SEAT BELT D-RING MOUNTING

STEERING:GEAR BOX (OTHER THAN RACK AND PINION)

VEHICLE DESCRIPTION: CLASS 8 HEAVY DUTY, AXLE BACK MODEL VEHICLES. THE DESIGN OF THE LOWER STEERING COLUMN SHAFT UNIVERSAL JOINT BOOT COULD ALLOW THE BOOT TO GET ENTANGLED IN THE UNIVERSAL JOINT.

VISIBILITY:WINDSHIELD WIPER/WASHER:MOTOR

ON CERTAIN TRUCKS EQUIPPED WITH VALEO WIPER SYSTEMS, THE WIPER MOTOR MAY BE SUSCEPTIVE TO SALT INTRUSION THAT COULD POSSIBLY LEAD TO A CONDITION WHERE THE CONNECTOR OVERHEATS TO A POINT WHERE THE CONNECTOR COULD IGNITE.

STEERING: STEERING WHEEL/HANDLE BAR

ON CERTAIN HEAVY DUTY CLASS 8 AXLE BACK VEHICLES, THE TELESCOPING STEERING SHAFT IN SOME DRIVING SITUATIONS COULD BOTTOM OUT AND SIDE LOAD THE STEERING GEAR INPUT SHAFT WHENEVER THE ADJUSTABLE STEERING COLUMN IS ADJUSTED TO THE LOWER POSITION.

SERVICE BRAKES, AIR:SUPPLY:CHECK VALVE

ON CERTAIN HEAVY DUTY TRUCKS EQUIPPED WITH MERITOR WABCO PNEUMATIC ANITLOCK BRAKE SYSTEM (ABS) VALVE PACKAGES, THE ASSEMBLY BOLTS ON THESE VALVE PACKAGES WERE NOT TIGHTENED CORRECTLY.

STEERING:GEAR BOX (OTHER THAN RACK AND PINION)

VEHICLE DESCRIPTION: HEAVY DUTY CLASS 8 TRUCKS. THE LOWER STEERING SHAFT MAY SIDE-LOAD THE STEERING GEAR INPUT SHAFT. THIS CONDITION COULD RESULT IN NON-UNIFORM STEERING WHEEL EFFORTS WHEN TURNING THE STEERING WHEEL. IN ADDITION, ONCE THE STEERING WHEEL TURN IS INITIATED, THE VEHICLE MAY CONTINU

POWER TRAIN:AXLE ASSEMBLY

ON CERTAIN HEAVY DUTY CLASS 8 TRUCKS, THE FORWARD AND/OR REAR DRIVE AXLE UPPER AXLE SEAT CAN BREAK ALLOWING THE AXLE TO SHIFT OUT OF ALIGNMENT.