2000 TOYOTA TUNDRA

EXTERIOR LIGHTING

CERTAIN PRO-A MOTORS CORNER LAMPS, TURN SIGNALS, AND HEADLIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE D

STRUCTURE:FRAME AND MEMBERS:UNDERBODY SHIELDS

TOYOTA IS RECALLING MODEL YEAR 2000-2003 TUNDRA VEHICLES ORIGINALLY SOLD IN OR CURRENTLY REGISTERED IN THE FOLLOWING STATES: CONNECTICUT, DELAWARE, ILLINOIS, INDIANA, KENTUCKY, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN, MINNESOTA, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND,

EXTERIOR LIGHTING:TAIL LIGHTS

VEHICLE DESCRIPTION: LIGHT DUTY TRUCKS. THE TAIL LIGHT SOCKET MAY HAVE BEEN IMPROPERLY MOLDED, RESULTING IN THE LOCKING TAB HAVING INSUFFICIENT FORCE TO RETAIN THE BULB.

EXTERIOR LIGHTING

CERTAIN AJ MOTORSPORT COMBINATION LAMPS SOLD AS REPLACEMENT LAMPS FOR USE ON THE ABOVE LISTED PASSENGER VEHICLES. COMBINATION LAMPS NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIAT

EXTERIOR LIGHTING:HEADLIGHTS

DOPE, INC. IS RECALLING 42,540 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES

TRAILER HITCHES

EQUIPMENT DESCRIPTION: THIS RECALL IS FOR TRAILER TOWING WIRE HARNESS CONVERTERS INSTALLED BY DEALERS OR FOR INSTALLATION ON 1999-2000 TOYOTA TUNDRA AND TACOMA VEHICLES. THE CONNECTORS INTEGRATE THE VEHICLE'S TAIL LIGHTS, BRAKE LIGHTS, AND TURN SIGNAL LIGHTS WITH THOSE EQUIPPED ON THE TRAILER, ARE

WHEELS

ON CERTAIN 4X2 VEHICLES EQUIPPED WITH AN ALLOY WHEEL TIRE UPGRADE (OPTIONS WM4, WM8, ZL1-ZL4, DH4, OR DH5) INSTALLED BY THE PROCESSING CENTERS IN JACKSONVILLE, FLORIDA OR COMMERCE, GEORGIA, A LABEL IDENTIFYING THE SPARE TIRE AS A TEMPORARY USE SPARE TIRE WAS NOT INSTALLED. THE UPGRADE INCLUDES 4 LA

On February 19, 2026, I contacted Hendrick Toyota Apex (1210 Laura Village Rd, Apex, NC 27523) to schedule repair for two open safety recalls on my 2000 Toyota Tundra (VIN: [XXX] ) under NHTSA Campaign #09V444, Toyota Campaigns BXD and BZD. The dealership incorrectly refused to perform either recall, stating that neither could be done in North Carolina because they only apply to cold climate states. This is incorrect — Campaign BZD was specifically created as a supplemental campaign to allow Toyota dealers outside the 20 cold climate states to inspect and repair covered vehicles. I was turned away on my first call. Only after calling back a second time to lodge a complaint did a different representative look up the recalls and confirm that Campaign BZD can in fact be performed at their location. Had I accepted the initial refusal, I would have been denied a free safety recall repair on a vehicle with 255,656 miles and visible frame corrosion. The dealership's staff appear to be untra

2000 toyota tundra SR5 4door 4.7 liter V8. Sunroof glass blew off on freeway at 65mph almost hit car behind me. No police report, no person injured. November 3, 2025.

2000 toyota tundra SR5 4door 4.7 liter V8. Sunroof glass blew off on freeway at 65mph almost hit car behind me. No police report, no person injured. November 3, 2025.

Excessive frame rust that is quickly progressing despite efforts to remedy. There was a recall due to this issue but I was told a few years ago by Toyota that my VIN was not covered. All the 2000 Tundra's have this issue with the frame rust but I was told I am not in the north east and would not be covered.

The brackets supporting the right rear brake line were severely rusted and failed. The brake line cracked at the juncture of the wheel cylinder attachment nut. Subsequently,there was a total loss of braking action on all wheels. The dual cylinder master cylinder failed to actuate the front brakes.THERE WAS NO BRAKING ACTION. The emergency brake had to be deployed in order to stop the vehicle.

The contact owns a 2000 Toyota Tundra. The contact stated that while driving approximately 30 MPH and hauling a boat, the subframe nearby the transmission cross member detached from the vehicle. The vehicle was towed to the residence. The contact was able to inspect the vehicle and became aware of severe rust on the subframe with several areas where the subframe had rusted through and had holes. The vehicle was not taken to a dealer or independent mechanic to be diagnosed or repaired. The manufacturer was not informed of the failure. The failure mileage was approximately 230,000.

Mileage: 230,000

This complaint is to document severe frame damage due to corrosion my 2000 Toyota Tundra. The rusted frames of the 2000-2003 Tundra’s are a well-documented problem that the Toyota Corporation has tried, unsuccessfully, to remedy in the past but continues to be a safety hazard to passengers and other innocent people when the frame finally fails. Some owners have been fortunate enough to have their frame replaced while others, like myself, have been told there is nothing available to remedy the problem. As seen in the attached pictures, I have significant corrosion along the frame walls where two pieces of steel were sandwiched together to reinforce the frame from where the gas tank is located to the rise where the bed attaches. These areas are crucial as the cross members of the frame attach to one another to form a solid body. Failure of this area would cause the truck cab to separate from the bed in the event of a crash, or even a deep pothole. It would also likely drop the gas

This complaint is to document severe frame damage due to corrosion my 2000 Toyota Tundra. The rusted frames of the 2000-2003 Tundra’s are a well-documented problem that the Toyota Corporation has tried, unsuccessfully, to remedy in the past but continues to be a safety hazard to passengers and other innocent people when the frame finally fails. Some owners have been fortunate enough to have their frame replaced while others, like myself, have been told there is nothing available to remedy the problem. As seen in the attached pictures, I have significant corrosion along the frame walls where two pieces of steel were sandwiched together to reinforce the frame from where the gas tank is located to the rise where the bed attaches. These areas are crucial as the cross members of the frame attach to one another to form a solid body. Failure of this area would cause the truck cab to separate from the bed in the event of a crash, or even a deep pothole. It would also likely drop the gas

The contact owns a 2000 Toyota Tundra. The contact received notification of NHTSA Campaign Number: 09V444000 (Structure); however, the part to do the recall repair was not yet available. The contact stated that the rear cross member was rusted. The local dealer was contacted and informed the contact that the recall repair could not be performed at their location. The vehicle was not diagnosed or repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the failure and contacted the dealer; however, the dealer advised that the recall repair could not be performed at the dealer location. The failure mileage was approximately 327,000. Parts distribution disconnect.

Mileage: 327,000

Frame of truck rusting apart Rust problem identified by independent dealer. I was told by repair shop that the frame could twist apart at any moment.

Frame of the vehicle is starting to rust, clear coat paint is wearing off and is starting to chip with small spots of rust on the roof and hood, lower ball joint failure due to corrosion and degraded components. Unknown why the lower ball joint failed. Vehicle is not in the rust belt but definitely experiences corrosion and suspension issues.

Frame of the vehicle is starting to rust, clear coat paint is wearing off and is starting to chip with small spots of rust on the roof and hood, lower ball joint failure due to corrosion and degraded components. Unknown why the lower ball joint failed. Vehicle is not in the rust belt but definitely experiences corrosion and suspension issues.

When I drive my vehicle it is difficult to apply the brakes on it and I feel like if I press too hard (which might be necessary if I need to suddenly stop) that the brakes might break or fail somehow. I have also noticed that underneath my truck, the frame is rotting out in certain areas and the leafs (steel long plates near the rear of the vehicle) is bending out of shape. There is a clanking noise near the front of the vehicle that concerns me as well when I pass through a small bump.

When I drive my vehicle it is difficult to apply the brakes on it and I feel like if I press too hard (which might be necessary if I need to suddenly stop) that the brakes might break or fail somehow. I have also noticed that underneath my truck, the frame is rotting out in certain areas and the leafs (steel long plates near the rear of the vehicle) is bending out of shape. There is a clanking noise near the front of the vehicle that concerns me as well when I pass through a small bump.

When I drive my vehicle it is difficult to apply the brakes on it and I feel like if I press too hard (which might be necessary if I need to suddenly stop) that the brakes might break or fail somehow. I have also noticed that underneath my truck, the frame is rotting out in certain areas and the leafs (steel long plates near the rear of the vehicle) is bending out of shape. There is a clanking noise near the front of the vehicle that concerns me as well when I pass through a small bump.

Lower ball joints must be replaced under a recall. Toyota has told me to contact you to look into it for me and to ask them to recall the part in question for my vehicle. My vehicle is a 2000 Tundra. Models from 2001-06 had a recall for lower ball joints. My truck has the exact same faulty part numbers as the later models. Part numbers are: 43340, 43330 for left and right. This part failing leads to catastrophic failures that causes the entire front end to fall to the ground and the wheels to smash into the fender wells. My truck has very low mileage and is starting to show signs of this failure. My biggest concern is safety especially with an older vehicle. A quick search on the internet will show you this happening to countless other 2000 tundras. This vehicle has been well cared for but this doesn’t fall under routine maintenance when the part has these known issues. My case number with Toyota is under my name [XXX] and the file number is [XXXXXXXX]. Thank you and feel free to re

Lower ball joints must be replaced under a recall. Toyota has told me to contact you to look into it for me and to ask them to recall the part in question for my vehicle. My vehicle is a 2000 Tundra. Models from 2001-06 had a recall for lower ball joints. My truck has the exact same faulty part numbers as the later models. Part numbers are: 43340, 43330 for left and right. This part failing leads to catastrophic failures that causes the entire front end to fall to the ground and the wheels to smash into the fender wells. My truck has very low mileage and is starting to show signs of this failure. My biggest concern is safety especially with an older vehicle. A quick search on the internet will show you this happening to countless other 2000 tundras. This vehicle has been well cared for but this doesn’t fall under routine maintenance when the part has these known issues. My case number with Toyota is under my name [XXX] and the file number is [XXXXXXXX]. Thank you and feel free to re

Badly rusted frame. Possibly eligible for recall (Toyota BXD, NHTSA #09V444). Mechanic noticed it and deemed it unsafe to drive. He contacted local dealer who declined to fix it. I contacted Toyota support and was told recall was expired. Need to know if I have any recourse.

The contact owns a 2000 Toyota Tundra. The contact stated that upon investigation, he became aware that the VIN was included in NHTSA Campaign Number: 09V444000 (Structure). The contact took the vehicle to the local dealer, where it was diagnosed with needing the frame to be replaced due to corrosion. The dealer informed the contact several unknown components needed to be repaired before the recall repair could be performed. The vehicle was not repaired. The manufacturer had not been informed of the failure. The failure mileage was approximately 190,000.

Mileage: 190,000

My husband and I were waking up to his alarm that went off at 5 am and he hit the snooze, during the snooze time we heard what sounded like a handgun go off so we both jumped up and opened the door leading to the outside of the house and immediately seen my truck engulfed in flames, the headlights were on and my grandson and husband both got Water hose's and proceeded to put the fire out but it was so hot and we were afraid that the truck would explode if we got any closer. My next door neighbor called 911 and firetruck arrived to finish putting out the fire but the entire truck was completely melted, at least the cab. The firefighter helped get the hood open so that my husband could disconnect the battery because the headlights were still on and the battery was throwing sparks.