Total Complaints
84 filings
BMW 528XI · model year
84 NHTSA complaints, and 1 active recall for this specific cohort.
NHTSA overall rating
5 / 5 ★
New Car Assessment Program
The 2013BMW528XI carries 84 consumer safety complaints in NHTSA's Office of Defects Investigation database for this specific model-year cohort. Within that volume, owners reported 0 crashes, 0 fires, 0 injuries, and 0 fatalities. For crash performance, NHTSA's New Car Assessment Program gave this cohort an overall 5/5 rating, with 4/5 front crash, 5/5 side crash, and 5/5 rollover scores derived from standardized barrier and dynamic tests.
Component-level analysis is where model-year complaints become actionable: the top complaint category for the 2013 528XI is engine with 31 filings, followed by power train (15) and electrical system (11). Concentration in one or two component groups is the classic signature of a systemic defect; a flat distribution usually reflects normal aging, warranty complaints, or isolated build-plant variability. This model year has 1 active recall campaign, which means the manufacturer is obligated to remedy the covered defect at no charge for the life of the vehicle — the full NHTSA campaign numbers are listed below.
NHTSA currently has 34 investigation files overlapping the 2013 528XI. Owners comparing this cohort against neighboring years should pair the counters above with the complaint-by-year trend on the parent model page — a spike in a single year often tracks to a platform refresh, a new transmission supplier, or an updated ECU calibration. Use the related-complaint feed below to read raw owner narratives before deciding whether any pattern here affects your specific use case.
Total Complaints
84 filings
Crashes Reported
0 reports
Source
NHTSA ODI
Federal complaints database
At or below the fleet median complaint volume.
| Component | Count |
|---|---|
| ENGINE | 31 |
| POWER TRAIN | 15 |
| ELECTRICAL SYSTEM | 11 |
| UNKNOWN OR OTHER | 6 |
| EXTERIOR LIGHTING | 5 |
| ENGINE AND ENGINE COOLING | 5 |
| AIR BAGS | 2 |
| FUEL/PROPULSION SYSTEM | 2 |
| SEATS | 1 |
| VEHICLE SPEED CONTROL | 1 |
| STEERING | 1 |
| AIR BAGS:FRONTAL:DRIVER CLOCKSPRING/SPIRAL CASSETTE | 1 |
| STRUCTURE:BODY | 1 |
| POWER TRAIN:DRIVELINE:DRIVESHAFT | 1 |
| SEAT BELTS | 1 |
EXTERIOR LIGHTING
BMW of North America, LLC (BMW) is recalling certain model year 2013 528i, 528i xDrive, 535i, 535i xDrive, 550i, 550i xDrive, and ActiveHybrid 5 vehicles. The rear reflex reflectors may not reflect enough light. As such, the vehicles fail to comply with the requirements of Federal Motor Vehicle Sa
My 2013 BMW 528i was serviced under recall 24V-608 (Coolant Pump Electrical Connector / DME). After the recall was marked complete, the car developed several serious failures: Coolant Pump / Connector (Recall Item) â The dealer refused to replace the coolant pump even though the recall notice from the government includes both the pump and connector. Shortly after, the water pump failed completely, causing âHigh Temperatureâ warnings and putting me at risk of sudden overheating and breakdown on the road. DME (Engine Control Unit) â This was supposedly updated during the recall, but it failed to detect existing problems. Before the recall, I was never warned about issues with the turbo or oil leaks. Immediately after the recall update, the car started misfiring and showing drivetrain malfunction. The recall did not prevent or detect the failures as promised. Valve Cover Gasket (Oil Leak) â After the recall, a severe valve cover oil leak appeared, causing lean air/fuel mixtur
My 2013 BMW 528i was serviced under recall 24V-608 (Coolant Pump Electrical Connector / DME). After the recall was marked complete, the car developed several serious failures: Coolant Pump / Connector (Recall Item) â The dealer refused to replace the coolant pump even though the recall notice from the government includes both the pump and connector. Shortly after, the water pump failed completely, causing âHigh Temperatureâ warnings and putting me at risk of sudden overheating and breakdown on the road. DME (Engine Control Unit) â This was supposedly updated during the recall, but it failed to detect existing problems. Before the recall, I was never warned about issues with the turbo or oil leaks. Immediately after the recall update, the car started misfiring and showing drivetrain malfunction. The recall did not prevent or detect the failures as promised. Valve Cover Gasket (Oil Leak) â After the recall, a severe valve cover oil leak appeared, causing lean air/fuel mixtur
My 2013 BMW 528i was serviced under recall 24V-608 (Coolant Pump Electrical Connector / DME). After the recall was marked complete, the car developed several serious failures: Coolant Pump / Connector (Recall Item) â The dealer refused to replace the coolant pump even though the recall notice from the government includes both the pump and connector. Shortly after, the water pump failed completely, causing âHigh Temperatureâ warnings and putting me at risk of sudden overheating and breakdown on the road. DME (Engine Control Unit) â This was supposedly updated during the recall, but it failed to detect existing problems. Before the recall, I was never warned about issues with the turbo or oil leaks. Immediately after the recall update, the car started misfiring and showing drivetrain malfunction. The recall did not prevent or detect the failures as promised. Valve Cover Gasket (Oil Leak) â After the recall, a severe valve cover oil leak appeared, causing lean air/fuel mixtur
Both of my headlights had moisture. I replaced the driverside first because you could literally see water sitting in the headlamp. Then I replaced the passengerside a year later because it was doing the same thing that the driver side started doing. I have not had any accidents nor has there been any damage to the front of the car. It appears that this is a known problem. My adaptive part is still not working, but the headlights are working. I have replaced my timinig chain and I keep getting a drivetrain malfunction warning. I am not getting a real answer as to why this is occuring.
Both of my headlights had moisture. I replaced the driverside first because you could literally see water sitting in the headlamp. Then I replaced the passengerside a year later because it was doing the same thing that the driver side started doing. I have not had any accidents nor has there been any damage to the front of the car. It appears that this is a known problem. My adaptive part is still not working, but the headlights are working. I have replaced my timinig chain and I keep getting a drivetrain malfunction warning. I am not getting a real answer as to why this is occuring.
the head lights are frequently burn out although there is no break in the light covers. It is unpredictable and unsafe especially because alot of my driving is at night.
The contact owns a 2013 BMW 528XI. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
The contact owns a 2013 BMW 528XI. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
The contact owns a 2013 BMW 528XI. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was contacted and confirmed that parts were not yet available. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
The contact owns a 2013 BMW 528XI. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was contacted and confirmed that parts were not yet available. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
The timing chain became stretched so that the valve timing with the pistons had been altered so that a valve face almost hit the top of a piston(one more tooth on the intake camshaft gear would have caused an impact between the piston top and a valve face causing the motor to stall and cease operation thereby causing the vehicle to lose power and possibly control). A timing chain should not stretch so as to cause a strike between a valve face and the top of a piston. Either the timing chain was of inferior quality or the automatic tensioner was inadequate to take up the slack as the chain wore.
The contact owns a 2013 BMW 528I. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was not yet available. The local dealer was contacted and confirmed that parts were not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
The contact owns a 2013 BMW 528I. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was not yet available. The local dealer was contacted and confirmed that parts were not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
The contact owns a 2013 BMW 528XI. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
The contact owns a 2013 BMW 528XI. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
-Drivetrain warning message was displayed, indicated to drive moderately, and moments later car sputtered and ceased to operate. Mechanic inspected and reported the timing chain failed and is to blame. Also, the engine may be impacted due to fraying parts that may have entered engine values over the course of time. Vehicle may be available for inspection for a short period of time (sold car to mechanic for very nominal amount). -My teenage daughter was driving the car when the above occurred and broke down on a busy highway. Thankfully, she avoided a collision. The police were called and the car towed. This could have been extremely harmful to both my daughter and the general public. -An independent mechanic diagnosed the issue and confirmed the issue. -The vehicle was not inspected by the manufacturer, police, or insurance. The manufacturer (BMW) did perform an extensive evaluation and repair of the coolant line approximately two months ago but did not mention this issue. -I belie
-Drivetrain warning message was displayed, indicated to drive moderately, and moments later car sputtered and ceased to operate. Mechanic inspected and reported the timing chain failed and is to blame. Also, the engine may be impacted due to fraying parts that may have entered engine values over the course of time. Vehicle may be available for inspection for a short period of time (sold car to mechanic for very nominal amount). -My teenage daughter was driving the car when the above occurred and broke down on a busy highway. Thankfully, she avoided a collision. The police were called and the car towed. This could have been extremely harmful to both my daughter and the general public. -An independent mechanic diagnosed the issue and confirmed the issue. -The vehicle was not inspected by the manufacturer, police, or insurance. The manufacturer (BMW) did perform an extensive evaluation and repair of the coolant line approximately two months ago but did not mention this issue. -I belie
The contact owns a 2013 BMW 528i. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System) however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
The contact owns a 2013 BMW 528i. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System) however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
See attached document for complaint.
Data as of 2025. Sources: NHTSA Office of Defects Investigation (ODI) complaints database, NHTSA recall campaign API, NHTSA NCAP crash-test ratings, and NHTSA FARS for fatality cross-reference.
Read our methodology — how this data is sourced, computed, and verified.