Investigations
REAR AXLE SEPARATION FROM VEHICLE
NHTSA Preliminary Evaluation PE97001 - closed, opened 1997-01-17.
NHTSA investigation PE97001 is a Preliminary Evaluation opened on 1997-01-17 and currently closed. The subject is tracked inside the Office of Defects Investigation queue. Latest activity on this investigation was logged on 1997-05-29 - NHTSA updates that field whenever an Information Request goes out, a supplement is filed, or a status change is recorded in the public docket.
A Preliminary Evaluation like PE97001 is the entry point of the federal defect-investigation process. NHTSA engineers scan complaint databases, field reports, and manufacturer data to decide whether an Engineering Analysis is warranted, whether a voluntary recall is already sufficient, or whether the pattern does not rise to a defect finding.
Investigators summarized the matter as follows: "THE SINGLE CONSUMER COMPLAINT RECEIVED BY NHTSA REPORTED AN INCIDENT IN WHICH APPLICATION OF THE SERVICE BRAKES OF THE SUBJECT VEHICLE PRECIPITATED AN UNFOREWARNED LOSS OF VEHICLE CONTROL AS THE LEFT REAR AXLE SEPARATED..." Investigations are the early-warning layer of the federal auto-safety system, sitting upstream of formal recalls and defect orders. Whether this one closes without action or escalates into an Engineering Analysis, the full history stays in the ODI archive so researchers, litigators, and buyers can pull the paper trail at any time.
Investigation Summary
THE SINGLE CONSUMER COMPLAINT RECEIVED BY NHTSA REPORTED AN INCIDENT IN WHICH APPLICATION OF THE SERVICE BRAKES OF THE SUBJECT VEHICLE PRECIPITATED AN UNFOREWARNED LOSS OF VEHICLE CONTROL AS THE LEFT REAR AXLE SEPARATED FROM THE VEHICLE. INSPECTION OF THE VEHICLE FOLLOWING THE INCIDENT DISCLOSED THAT THE LEFT REAR DUAL WHEELS HAD JAMMED INTO THE FENDER WELL AS THE AXLE SEPARATED FROM THE LEFT LEAF SPRING ASSEMBLY. THE NUTS WERE REPORTED MISSING FROM THE TWO U-BOLTS WHICH CLAMP THE REAR AXLE TO THE LEAF SPRINGS. THE INCIDENT OCCURRED ON A VEHICLE WITH A REPORTED ODOMETER READING OF 397 MILES. NO ADDITIONAL CONSUMER COMPLAINTS REGARDING THE ALLEGED DEFECT IN THE SUBJECT VEHICLES WERE RECEIVED BY THIS AGENCY SINCE THIS PE WAS INITIATED. INQUIRY TO THE MANUFACTURER DISCLOSED NO OTHER CONSUMER COMPLAINTS OR FIELD REPORTS OF SIMILAR NATURE, AND THREE WARRANTY CLAIMS WERE IDENTIFIED AS POTENTIALLY RELEVANT. THESE DATA APPLY TO THE 11,499 C/D 30-SERIES VEHICLES SOLD THROUGH MID-FEBRUARY, 1997, FROM THE TOTAL OF 27,385 BUILT AT GM'S FLINT ASSEMBLY PLANT. THE INQUIRY WAS LIMITED TO VEHICLES PRODUCED AT FLINT BECAUSE THE LOW MILEAGE OF THE COMPLAINANT VEHICLE SUGGESTED THAT ASSEMBLY/PRODUCTIION PROCEDURES MIGHT BE A SOURCE OF THE ISSUE. ODI ALSO CONTACTED THE GENERAL SERVICE ADMINISTRATION'S FLEET MANAGEMENT OFFICE AND DISCUSSED THE ISSUE. THEY SENT REQUESTS TO ALL OF THEIR REGIONAL FLEET MANAGERS ACROSS THE UNITED STATES, FOR ANY INFORMATION OR REPORTS OF FAILURES WITHIN THE GSA'S TOTAL FLEET OF "SEVERAL HUNDRED TRUCKS." NO INCIDENT REPORTS WERE RECEIVED IN RESPONSE TO THESE INQUIRIES. THE APPLICATION OF PROPER TORQUES ON THE U-BOLT NUTS DURING VEHICLE ASSEMBLY IS ACCOMPLISHED BY AUTOMATED PNEUMATIC TOOLS THAT REQUIRE THE STATION OPERATOR TO ABSERVE AND MARK THE TORQUED ASSEMBLIES ACCORDING TO A COLOR CODE, AND TO NOTE ANY HIGH- OR LOW-TORQUE CONDITIONS ON AN INSPECTION TICKET. STATISTICAL REPORTS FOR THE ASSEMBLY FASTENING SYSTEM ARE PULLED TWICE PER SHIFT AND REVIEWED BY PO
About This Investigation Type
A Preliminary Evaluation (PE) is the first phase of NHTSA's investigation process. It is opened when the agency identifies a potential safety defect pattern, usually triggered by consumer complaints, manufacturer reports, or field monitoring. During a PE, NHTSA gathers information to determine whether a formal engineering analysis is warranted.
Data from NHTSA Office of Defects Investigation. Cross-references: NHTSA recall campaign API and NHTSA FARS where fatality records overlap. PlainCars does not rate or recommend vehicles. about how PlainCars sources NHTSA data.
Read our methodology - how this data is sourced, computed, and verified.