Investigations
Air in brake system
NHTSA Engineering Analysis EA09014 - closed, opened 2009-10-19 and involving the HONDA ODYSSEY.
NHTSA investigation EA09014 is a Engineering Analysis opened on 2009-10-19 and currently closed. The subject of record is HONDA ODYSSEY, which places this file inside the Office of Defects Investigation queue for HONDA. Latest activity on this investigation was logged on 2010-05-11 - NHTSA updates that field whenever an Information Request goes out, a supplement is filed, or a status change is recorded in the public docket.
An Engineering Analysis like EA09014 is the deeper technical phase that follows a PE. NHTSA requests design, warranty, and field-failure data from the manufacturer, conducts its own testing when needed, and determines whether the evidence supports a safety defect finding that would compel a recall.
Investigators summarized the matter as follows: "By letter dated March 15, 2010, American Honda Motor Corp. (HMC) notified the National Highway Traffic Safety Administration (NHTSA) that it will conduct a safety recall (NHTSA Recall No. 10V-098) to address a defect in..." Investigations are the early-warning layer of the federal auto-safety system, sitting upstream of formal recalls and defect orders. Whether this one closes without action or escalates into an Engineering Analysis, the full history stays in the ODI archive so researchers, litigators, and buyers can pull the paper trail at any time. Related HONDA files, listed below, give context on whether this is an isolated concern or part of a broader pattern across the brand.
Investigation Summary
By letter dated March 15, 2010, American Honda Motor Corp. (HMC) notified the National Highway Traffic Safety Administration (NHTSA) that it will conduct a safety recall (NHTSA Recall No. 10V-098) to address a defect in approximately 412,000 model year (MY) 2007 and 2008 Honda Odyssey and Element vehicles equipped with an ABS/VSA/TCS modulator. The recalled Odyssey vehicles were built from August 2006 August 2008. The recalled Element vehicles were built from July 2006 to July 2008. According to Honda, during an initial self-check process that occurs shortly after each engine ignition cycle, the self-diagnostic software for the VSA modulator allows a vacuum condition that can exist for several hours, allowing air to enter the VSA modulator pump. Over time, and thousands of engine ignition cycles, it is possible for enough air to enter the system to result in a brake pedal that feels soft or lower to the floor. If the customer does not have any brake service or maintenance performed over a period of months or years, the system can continue to accumulate enough air to affect braking performance. To correct the safety defect, Honda dealers will remove existing air in the brake system then apply sealant and caps to the VSA modulator to prevent air from entering the brake system, free of charge. The action taken by Honda is sufficient to resolve the issues raised by this investigation. The agency will continue to monitor this issue and reserves the right to take further action if warranted by the circumstances. Accordingly, this investigation is closed.
About This Investigation Type
An Engineering Analysis (EA) is the in-depth phase following a Preliminary Evaluation. NHTSA engineers conduct testing, collect data from manufacturers, and perform detailed technical analysis to determine whether a safety defect exists. An EA may lead to a voluntary recall by the manufacturer or, in rare cases, a mandatory recall order.
Other HONDA Investigations
Inaccurate Rear Passenger Seat Belt Warning Status
Loss of Motive Power
Inadvertent Deployment of Side Air Bags
Engine failure
No Restart After Auto Start/Stop Engages
Data from NHTSA Office of Defects Investigation. Cross-references: NHTSA recall campaign API and NHTSA FARS where fatality records overlap. PlainCars does not rate or recommend vehicles. about how PlainCars sources NHTSA data.
Read our methodology - how this data is sourced, computed, and verified.